Troubleshooting Cisco Wireless Enterprise Network

Here you have the best Cisco 300-370 practice exam questions

You have 57 total questions to study from
Each page has 5 questions, making a total of 12 pages
You can navigate through the pages using the buttons at the bottom
This questions were last updated on January 30, 2026
This site is not affiliated with or endorsed by Cisco.

Question 1 of 57

Refer to the exhibit.
Exam 300-370: Question 1 - Image 1

Exam 300-370: Question 1 - Image 1

A client reports being unable to log into the wireless network. According to the output, which network information should be verified?

A.

the Failed Attempts log on the authentication server

B.

that the AP has IP connectivity to the authentication server

C.

that the user has an account on the authentication server

D.

that the authentication and accounting configuration are correct

Suggested Answer: B

Community votes

No votes yet

Question 2 of 57

Refer to the exhibit.
Exam 300-370: Question 2 - Image 1

Exam 300-370: Question 2 - Image 1

A client reports being unable to log into the wireless network, which uses PEAPv2. Which two issues appear in the output? (Choose two.)

A.

The AP has the incorrect RADIUS server address.

B.

There is a problem with the client supplicant.

C.

The AP has lost IP connectivity to the authentication server.

D.

The authentication server is misconfigured on the controller.

E.

The EAP client timeout value should be increased.

F.

The authentication server is misconfigured in the WLAN.

Suggested Answer: A, C

Community votes

No votes yet

Question 3 of 57

An engineer must open a support case with Cisco TAC. Which two commands verify the model and serial number of a controller? (Choose two.)

A.

show sysinfo

B.

show udi

C.

show inventory

D.

show boot

E.

show tech-support

Suggested Answer: A, B

Community votes

No votes yet

Question 4 of 57

While reviewing CleanAir data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default severity level has been changed. Which value does the engineer select to reset the severity level to its factory setting?

A.

informational

B.

major

C.

minor

D.

warning

E.

critical

Suggested Answer: D

Community votes

No votes yet

Question 5 of 57

An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications?

A.

rogue AP containment

B.

RF detection

C.

switch port tracing

D.

wire detection

E.

Cisco Prime Infrastructure location services

Suggested Answer: A

Community votes

No votes yet