Building HPE SDN and FlexNetwork Solutions

Here you have the best HP HPE0-Y53 practice exam questions

You have 105 total questions across 21 pages (5 per page)
These questions were last updated on February 15, 2026
This site is not affiliated with or endorsed by HP.

Question 1 of 105

A network administrator is planning a flow table entry that provides fast failover for the traffic flow in case a link fails. Which key element would the flow entry contain?

a group identifier that specifies at least two output ports

a backup set action that modifies the packet and sends it to the controller

a forward action to the reserved port NEAREST_ACTIVE

a go-to-table action that sends traffic to another table if the port is down

Question 2 of 105

An HP switch is controlled by an HP VAN SDN Controller. An SDN application attempts to create a flow entry that forwards traffic out Port 2 on this HP switch.
However, the switch does not forward any traffic out this port. The exhibit shows the status for ports on that switch.
Exam HPE0-Y53: Question 2 - Image 1

Based on the information shown in the exhibit, why does the switch not forward the traffic?

Port 2 is part of a link aggregation with Port 1.

Port 2 is down.

Port 2 is placed in the discarding state by spanning tree.

Port 2 does not support a VLAN on which OpenFlow is enabled.

Question 3 of 105

Refer to the exhibit.
Exam HPE0-Y53: Question 3 - Image 1

The network administrator is configuring interface Ten-GigabitEthernet 1/0/2 to receive FCoE traffic from the connected server. The administrator has created
VSAN 10, which is associated with VLAN 101.
What else must the administrator do to complete the configuration?

Assign VLAN 101 as the PVID for interface Ten-GigabitEthernet 1/0/2.

Change interface Ten-GigabitEthernet 1/0/2 to a hybrid port;assign VLANs 10 and 101 as untagged VLANs.

Change interface Ten-GigabitEthernet 1/0/2 to a trunk port and permit VLAN 101.

Change interface Ten-GigabitEthernet 1/0/2 to a hybrid port;assign VLAN 10 as a tagged VLAN and VLAN 101 as an untagged VLAN.

Question 4 of 105

Refer to the exhibit.
Exam HPE0-Y53: Question 4 - Image 1

The exhibit shows the four OpenFlow table entries for an HP ProVision switch that is controlled by an HP VAN SDN Controller. The switch uses active mode for the OpenFlow instance.
The network administrator wants the switch to have this behavior:
The current entries have an error. How should the administrator change these entries to resolve the error?

Remove the entry for table 0.

Give each entry its own unique priority value.

Change the table ID for the entry that matches "eth_type: arp" to 200.

Add a table miss entry that outputs traffic normally.

Question 5 of 105

Refer to the exhibit.
Exam HPE0-Y53: Question 5 - Image 1

A network administrator is planning an MPLS and VPLS Martini solution to connect customer sites 1, 2, and 3. How many pseudowires must the administrator configure?

two; two on PE-1, with one connected to PE-2 and PE-3

one; one on PE-1, connected to both PE-2 and PE-3

four; two on PE-1, one on PE-2, and one on PE-3

six; two each on PE-1, PE-2, and PE-3

About the HP HPE0-Y53 Certification Exam

About the Exam

The HP HPE0-Y53 (Building HPE SDN and FlexNetwork Solutions) validates your knowledge and skills. Passing demonstrates proficiency and can boost your career prospects in the field.

How to Prepare

Work through all 105 practice questions across 21 pages. Focus on understanding the reasoning behind each answer rather than memorizing responses to be ready for any variation on the real exam.

Why Practice Exams?

Practice exams help you familiarize yourself with the question format, manage your time, and reduce anxiety on the test day. Our HPE0-Y53 questions are regularly updated to reflect the latest exam objectives.