Advanced Technical Test Analyst

Here you have the best ISTQB ATTA practice exam questions

  • You have 65 total questions to study from
  • Each page has 5 questions, making a total of 13 pages
  • You can navigate through the pages using the buttons at the bottom
  • This questions were last updated on October 30, 2025
  • This site is not affiliated with or endorsed by ISTQB.
Question 1 of 65
An embedded software company is considering to improve the quality of its software components to be delivered to the integration team. After studying various experience papers that report a higher level of quality for software components, two main alternative techniques are identified: static analysis and dynamic analysis. In deciding which one is most applicable and how they relate to each other a detailed study is performed.
Which of the following are TWO key similarities between static analysis and dynamic analysis?
    Correct Answer: C, E

Question 2 of 65
If you are flying with an economy ticket, there is a possibility that you may get upgraded to business class, especially if you hold a gold card in the airlines frequent flier program. If you dont hold a gold card, there is a possibility that you will get bumped off the flight if it is full and you check in late. This is shown in the figure hereafter. Note that each box (i.e. statement) has been numbered.

Three tests have been run:
Test 1: Gold card holder who gets upgraded to business class
Test 2: Non-gold card holder who stays in economy
Test 3: A person who is bumped from the flight
What is the statement coverage of these three tests?
Exam ATTA: Question 2 - Image 1
    Correct Answer: C

Question 3 of 65
As part of a risk analysis, technical risks are analyzed. Which TWO factors influence technical risk?
    Correct Answer: A, C

Question 4 of 65
A component has been analyzed as being highly critical. Which of the following structure-based test design techniques provides the highest level of coverage?
    Correct Answer: C

Question 5 of 65
The result of a product risk analysis performed on components I, II and III of the airplane control system shows the following risk matrix:
Exam ATTA: Question 5 - Image 1
The project wants to mitigate the risks by defining different types of coverage depending on the risk level of the components. Which of the following would be a meaningful solution for setting the coverage targets?
    Correct Answer: A