Question 6 of 68

What are two ways to determine when the IBM Spectrum Protect Server database was last backed up? (Select two.)

Answer

Suggested Answer

The suggested answer is B, E.

Question 7 of 68

Which component is used to transfer data on IBM Spectrum Protect for Virtual Environments?

Answer

Suggested Answer

The suggested answer is D.

The data mover is part of the IBM Spectrum Protect for Virtual Environments: Data Protection for VMware program that backs up VMs to the IBM Spectrum
Protect server. The data mover resides on the server where Data Protection for VMware is installed.
References:
https://www.ibm.com/support/knowledgecenter/SSERB6_8.1.0/ve.user/t_ve_dpext_cfg_datamover.html
Question 8 of 68

Which two empty recovery log directories must be defined before configuration of the IBM Spectrum Protect server instance? (Select two.)

Answer

Suggested Answer

The suggested answer is C, E.

IBM Spectrum Protect Configuration best practices include: separate the server database, the active log, the archive log, and disk storage pools from each other.
References:
https://www.ibm.com/support/knowledgecenter/SSEQVQ_8.1.0/perf/t_optim_config.html
Question 9 of 68

In a customer environment, there are two IBM Spectrum Protect servers, ORION and TITAN, managing the backups for the entire data center. Server to server communication has been configured, however command routing fails. Both these servers are reachable over the TCP/IP network. What is the first step to diagnose this problem?

Answer

Suggested Answer

The suggested answer is C.

Open a command prompt, the server administrative command line, on the one server and ping the other server to make sure communication is active and that a firewall is not interferring.
Note: The administrative command-line client is a program that runs on a file server, workstation, or mainframe. It is installed as part of the IBM Spectrum Protect server installation process. The administrative client can be accessed remotely.
From the administrative client, you can issue any server commands.
References:
http://www-01.ibm.com/support/docview.wss?uid=swg21640744
Question 10 of 68

Which minimum parameter is required in the Windows client options file to set up the IBM Spectrum Protect Administrative Command Line Client communication with the IBM Spectrum Protect Server?

Answer

Suggested Answer

The suggested answer is C.

In all administrative client modes, you can use options to modify administrative client session responses.
TCPServeraddress specifies a TCP/IP server address for an IBM Spectrum Protect server. The TCPSERVERADDRESS option is only supported by administrative clients that are running on Windows operating systems and is valid on the Windows administrative client command line.
Incorrect Answers:
A: Windows clients use the server name to identify which passwords belong to which servers. Changing the server name after the clients are connected forces the clients to reenter the passwords.
References:
https://www.ibm.com/support/knowledgecenter/SSEQVQ_8.1.0/srv.reference/r_cmdline_adclient_options.html
IBM Spectrum Protect for Windows, Version 8.1.0, Administrator's Reference, page 1266