Question 6 of 60
You are sizing a FlexPod Virtual Desktop solution for a customer with 500 virtual desktops in a shared Remote Desktop Services (RDS) topology.
In this scenario, which Cisco best practice should you use?
Answer

Suggested Answer

The suggested answer is B.

Question 7 of 60
You have a FlexPod solution that consists of a NetApp AFF A800 storage system, a Cisco MDS 9148S switch, and a Cisco UCS 6232 Fabric Interconnect. You want to upgrade NetApp ONTAP software on the AFF A800 to take advantage of a new feature.
In this scenario, which three tools would enable you to verify if the upgrade would be performed safely? (Choose three.)
Answer

Suggested Answer

The suggested answer is A, D, E.

Community Votes3 votes
ADESuggested
100%
Question 8 of 60
You are designing a new FlexPod solution to use with VMware vSphere by using NFS datastores and want to ensure maximum availability by using a vPC.
In this scenario, on which Cisco component would you configure vPC interfaces?
Answer

Suggested Answer

The suggested answer is C.

Question 9 of 60
What are three requirements for all FlexPod Datacenter solutions? (Choose three.)
Answer

Suggested Answer

The suggested answer is A, D, E.

The three requirements for all FlexPod Datacenter solutions are: two NetApp storage controllers in a high-availability (HA) pair configuration, two Cisco UCS 6200, 6300, or 6400 Series Fabric Interconnects in a redundant configuration, and redundant boot-from-SAN LUN paths. These components ensure high availability, reliable management of network traffic, and redundancy in storage management.

Community Votes1 vote
ABCMost voted
100%
Question 10 of 60
A customer wants to deploy a FlexPod Datacenter solution in a limited amount of rack space. After planning for the networking and storage devices required for the deployment, they realize they have six rack units of space remaining. They need to install as many servers as possible in this available rack space.
In this scenario, which solution allows them to accomplish their objective?
Answer

Suggested Answer

The suggested answer is D.

The eight Cisco UCS B200 M5 blade servers are the optimal solution for fitting the maximum number of servers into the remaining six rack units. The UCS B200 M5 blades are half-width servers and can be installed in a UCS 5108 chassis, which is 6U in height and can hold up to eight blades. This allows for the maximum density of servers in the available rack space.