Refer to the exhibit:

A company acquires ten barcode scanners to run inventory tasks. These WiFi devices support WPA2-PSK security only. The network administrator deploys a WLAN named scanners using the configuration shown in the exhibit. What must the network administrator do next to ensure that the scanner devices successfully connect to their SSID?

Refer to the exhibit.

A network administrator deploys DSCP based prioritization in the entire wired network to improve voice quality for a SIP-based IP telephony system used by the company. However, users report that calls they make from WLAN have poor audio quality, while desktop phones do not experience the same problem. The network administrator makes a test call and looks in the datapath session table.

Based on the output shown in the exhibit, what is one area that the network administrator should focus on?

An organization has several RAPs at different locations that broadcast two SSIDs. The internet-only SSID is in bridge/always mode, and the corporate SSID is in split-tunneling/standard mode. The network administrator deploys 10 more RAPs in different locations.

Users can successfully connect to the corporate SSID that is propagated by a RAP at a remote location. However, they report that it takes too long to access public internet web sites.

What is one part of the configuration that should be checked by the network administrator to verify this RAP deployment?

HOTSPOT -

A network administrator wants to receive a warning level alarm every time the noise floor rises above -82 dBm on any of the AP radios.

Which alarm definition must the network administrator create to accomplish this?

An Aruba Mobility Master (MM) - Mobility Controller (MC) solution is connected to a wired network that is ready to prioritize DSCP marked traffic. A group of WMM-enabled clients sends traffic marked at L2 only.

What must the network administrator do to map those markings to DSCP equivalent values when traffic is received by the APs?