Fortinet FCSS_SDW_AR-7.6 Practice Questions & Answers

Question 6 of 62

Refer to the exhibit.

SD-WAN Network Topology -
Exam FCSS_SDW_AR-7.6: Question 6 - Image 1

You want to configure SD-WAN on a network, as shown in the exhibit.
The network contains many FortiGate devices. Some are used as next-generation firewalls (NGFW), and some are installed with extensions such as FortiSwitch, FortiAP, or FortiExtender.
Which factors should you consider when planning your deployment?

You should build multiple SD-WAN topologies. Each topology should contain only one type of extension.

You can build an SD-WAN topology that includes all devices. The hubs must be devices without extensions.

You should exclude the FortiGate devices with FortiLink connection from the SD-WAN topology.

You can build an SD-WAN topology that includes all devices. The hubs can be FortiGate devices with FortiExtender.

Question 7 of 62

Refer to the exhibit.
Exam FCSS_SDW_AR-7.6: Question 7 - Image 1

You configure the SD-WAN rule ID 4 with two members (port1 and port2) and the strategy lowest cost (SLA).
Which two statements about the session shown in the exhibit are true? (Choose two.)

FortiGate steered this flow according to the application detected and the outgoing interface is port3.

FortiGate will reevaluate this session if the outgoing interface goes down.

FortiGate steered this flow according to the SD-WAN rule 4.

FortiGate will reevaluate this session if you update the routing table.

Question 8 of 62

Refer to the exhibit.
FortiGate router policy and diagnose output
Exam FCSS_SDW_AR-7.6: Question 8 - Image 1

How does FortiGate handle the traffic with the source IP 10.0.1.130 and the destination IP 128.66.0.125?

FortiGate steers the traffic flow through port2.

FortiGate routes the traffic flow according to the FIB.

FortiGate load balances the traffic flow through port1 and port2.

FortiGate drops the traffic flow.

Question 9 of 62

Your FortiGate is in production. To optimize WAN link use and improve redundancy, you enable and configure SD-WAN.
What must you do as part of this configuration update process?

Replace references to interfaces used as SD-WAN members in the routing configuration.

Disable the interface that you want to use as an SD-WAN member.

Replace references to interfaces used as SD-WAN members in the firewall policies.

Purchase and install the SD-WAN license, and reboot the FortiGate device.

Question 10 of 62

Refer to the exhibit that shows a diagnose output on a FortiGate device.
Exam fcss-sdw-ar-7-6: Image 1

Based on the output shown in the exhibit, what can you conclude about the device role and how it handles health checks?

The device is a spoke and it receives health-check measures for the tunnels of another spoke.

The device is a hub and it receives health-check measures for the tunnels of a spoke.

The device is a spoke and it provides embedded health-check measures for each tunnel to the hub.

The device is a hub and it receives embedded health-check measures for each tunnel from the spoke.