CWNP CWDP-304 Exam Questions

Question 6 of 60

In WLAN design software, what is an example of a project parameter that can be defined before importing files or performing design actions?

A.

AP locations

B.

AP type selection

C.

Minimum required signal strength

D.

Floor plan

Question 7 of 60

For a point-to-point bridge link spanning 1200 meters, which antenna is the most appropriate and requires the least Intentional Radiator power?

A.

2.2 dBi omnidirectional

B.

11 dBi omnidirectional

C.

11 dBi dish

D.

5 dBi patch

Question 8 of 60

You are tasked with conducting a site survey to measure signal strength, throughput, and latency. What type of survey should you perform?

A.

Perform a passive survey using a laptop’s built-in wireless adapter

B.

Perform a passive survey using a USB wireless adapter

C.

Perform an active survey using a laptop’s built-in adapter

D.

Perform a passive survey using a special monitor mode adapter

Question 9 of 60

During the design process of a point-to-point bridge link, which step should be taken to minimize Co-Channel Interference (CCI) and Adjacent Channel Interference (ACI)?

A.

Choose a channel on the 5 GHz band outside of the UNII-1 and UNII-3 channels

B.

Choose a channel on the 2.4 GHz band other than the over used 1, 6 and 11

C.

Install the antennas and choose the least busy channel using trial and error problem solving

D.

Perform an outdoor site survey in the area of both buildings and determine the best channel to use

Question 10 of 60

Before beginning the actual design process in most WLAN design tools, what action is typically required after defining project parameters or completing the project creation wizard?

A.

Place APs

B.

Define cabling

C.

Import a floor plan

D.

Define wall materials