Cisco 300-410 Certification Practice Questions & Answers

Question 6 of 620

Refer to the exhibit. An engineer configures a static route on a router, but when the engineer checks the route to the destination, a different next hop is chosen.

What is the reason for this?

A.

Dynamic routing protocols always have priority over static routes.

B.

The metric of the OSPF route is lower than the metric of the static route.

C.

The configured AD for the static route is higher than the AD of OSPF.

D.

The syntax of the static route is not valid, so the route is not considered.

Question 7 of 620

Refer to the exhibit. An engineer is trying to generate a summary route in OSPF for network 10.0.0.0/8, but the summary route does not show up in the routing table.

Why is the summary route missing?

A.

The summary-address command is used only for summarizing prefixes between areas.

B.

The summary route is visible only in the OSPF database, not in the routing table.

C.

There is no route for a subnet inside 10.0.0.0/8, so the summary route is not generated.

D.

The summary route is not visible on this router, but it is visible on other OSPF routers in the same area.

Question 8 of 620

Refer to the exhibit. An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route.

Which action blocks the route?

A.

Use an extended access list instead of a standard access list.

B.

Change sequence 10 in the route-map command from permit to deny.

C.

Use a prefix list instead of an access list in the route map.

D.

Add this statement to the route map: route-map RM-OSPF-DL deny 20.

Question 9 of 620

What is a prerequisite for configuring BFD?

A.

Jumbo frame support must be configured on the router that is using BFD.

B.

All routers in the path between two BFD endpoints must have BFD enabled.

C.

Cisco Express Forwarding must be enabled on all participating BFD endpoints.

D.

To use BFD with BGP, the timers 3 9 command must first be configured in the BGP routing process.

Question 10 of 620

DRAG DROP -

Drag and drop the OSPF adjacency states from the left onto the correct descriptions on the right.

Select and Place: