Question 6 of 1003
Prior to enabling PPPoE in a virtual private dialup network group, which task must be completed?
Correct Answer:
Enabling PPPoE in a VPDN Group -
Perform this task to enable PPPoE in a virtual private dial-up network (VPDN) group.
Restrictions -
This task applies only to releases prior to Cisco IOS Release 12.2(13)T.
SUMMARY STEPS -
1. enable
terminal
2. configure
3. vpdn enable
4. vpdn-group
5. request-dialin
6. protocol pppoe
DETAILED STEPS -
Reference:
http://www.cisco.com/en/US/docs/ios/12_2t/12_2t2/feature/guide/ftpppoec_support_TSD_Island_of_Content_Chapter.html Explanation
Perform this task to enable PPPoE in a virtual private dial-up network (VPDN) group.
Restrictions -
This task applies only to releases prior to Cisco IOS Release 12.2(13)T.
SUMMARY STEPS -
1. enable
terminal
2. configure
3. vpdn enable
4. vpdn-group
5. request-dialin
6. protocol pppoe
DETAILED STEPS -
Reference:
http://www.cisco.com/en/US/docs/ios/12_2t/12_2t2/feature/guide/ftpppoec_support_TSD_Island_of_Content_Chapter.html Explanation
Question 7 of 1003
A network engineer has been asked to ensure that the PPPoE connection is established and authenticated using an encrypted password. Which technology, in combination with PPPoE, can be used for authentication in this manner?
Correct Answer:
Question 8 of 1003
A corporate policy requires PPPoE to be enabled and to maintain a connection with the ISP, even if no interesting traffic exists. Which feature can be used to accomplish this task?
Correct Answer: B
A new interface configuration command, dialer persistent, allows a dial-on-demand routing (DDR) dialer profile connection to be brought up without being traffic. When configured, the dialer persistent command starts a timer when the dialer interface starts up and starts the connection when the timer expires. If interesting traffic arrives before the timer expires, the connection is still brought up and set as persistent. The command provides a default timer interval, or you can set a custom timer interval.
To configure a dialer interface as persistent, use the following commands beginning in global configuration mode:
B
To configure a dialer interface as persistent, use the following commands beginning in global configuration mode:
BQuestion 9 of 1003
Which PPP authentication method sends authentication information in clear text?
Correct Answer: D
Question 10 of 1003
Which protocol uses dynamic address mapping to request the next-hop protocol address for a specific connection?
Correct Answer: A