Here you have the best VMWare 2V0-41.20 practice exam questions
An NSX administrator noticed that the nsxcli command times out after 600 secs of idle time.
Which CLI command disables the nsxcli time out value on NSX Manager?
To disable the nsxcli timeout on NSX Manager, the correct command is 'set cli-timeout 0'. This sets the inactivity timeout to 0 seconds, effectively disabling it.
An NSX administrator is configuring the KVM hypervisor host as a transport node and wants to apply the Failover Order as a NIC teaming policy.
Which profile allows the administrator to configure the NIC Teaming policy as Failover Order?
To configure the NIC Teaming policy as Failover Order on a KVM hypervisor host, the administrator should use the Uplink Profile. The Uplink Profile allows the configuration of various settings, including the NIC Teaming policies, which can be set to Failover Order to determine the order in which NICs are used for network traffic.
Which two choices are prerequisites to configure NSX-T on VDS? (Choose two.)
To configure NSX-T on vSphere Distributed Switch (VDS), two primary prerequisites are required: a vSphere Distributed Switch version of at least 7.0, and a Maximum Transmission Unit (MTU) setting of 1600. VDS 7.0 provides the necessary features and capabilities to support NSX-T, while an MTU of 1600 ensures that the network can handle the overhead required by NSX-T encapsulation protocols such as Geneve. An MTU of 1500 or 1400 would be insufficient for this purpose.
Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal transport node?
The command 'ifconfig' is used on Unix-based systems, including Linux, to display the configuration of network interfaces. Since a bare metal transport node typically uses a Linux-based operating system, 'ifconfig' would be the appropriate command to display the network configuration of the Tunnel Endpoint (TEP) IP.
Which three steps are required to create an IPsec VPN tunnel? (Choose three.)
To create an IPsec VPN tunnel, three essential steps are required: First, create an IPsec service to initiate the VPN setup process. Second, add a local endpoint, which serves as the local termination point for the VPN tunnel. Finally, configure an IPsec session to establish secure communication details and parameters for the tunnel.