2v0-4123 Exam - Question 25

Question

HOTSPOT -Refer to the exhibit. Which two items must be configured to enable OSPF for the Tier-0 Gateway in the image? Mark your answers by clicking twice on the image.

Examice · Accepted Answer

.

descentguy2021 · Answer

Area Definition & OSPF Configured Interfaces

https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.2/administration/GUID-5BEC626C-5312-467D-B873-8E117349E9FC.html

ImDOS · Answer

must be interface and area

bpexam · Answer

Erea Definition & OSPF configured interfaces

stjwh1 · Answer

I  think that
1. Enable OSPF 
2. Set Area Definition.

avid_researcher · Answer

OSPF configured interfaces "set" is black. this means that no existing external interface is defined on the GW. Could just be a bad image but based on this you would need to click interfaces and add the external interface first, then set the area definition under OSPF before you would be able to set the OSPF configured interfaces.

BenW1191 · Answer

You need to enable OSPF (already enabled), set the Area Definition and configure the interfaces. The anwser is 'Area Definition' and 'OSPF Configured Interfaces'. I saw that on multiple diffrent exam preps as well.

Nubee · Answer

Since OSPF is already enabled, which means Routing and Interfaces are already set.
While in the enabled OSPF section next thing would be to do:   1. Area Definition - Add area Definition and then 2. OSPF Configured Interfaces - Click Set

2v0-4123 Exam - Question 25

Discussion