A developer applied a conditional breakpoint to the Write Line activity inside the following While loop:
The Breakpoint Settings panel is shown as follows:
How many times will "UiPath" be displayed in the Output panel before the process goes into a Paused state in Debug mode?
The Write Line activity within the While loop will increment the 'count' variable starting from 1 until it reaches less than 12. The breakpoint is set to pause the execution after the Write Line activity meets the condition 'count Mod 2 = 0' three times. This condition implies the breakpoint will pause on every third even number. Starting from 1, the 'count' will become 2, 4, 6, 8, and 10 on subsequent even numbers. Thus, 'UiPath' will be displayed 5 times (when 'count' equals 2, 4, 6, 8, 10) before the process goes into a Paused state in Debug mode.
Tested in Studio ! Uipath will be displayed 5 times before stop at the breakpoint !
correct answer is B. Hit Count = Specifies the number of times the condition must be met before the execution breaks.
Correct is 5 , tested in studio
Ans. will be B because the write line activity will only be executed when the condition will be met and the condition will be met thrice so the correct ans. will be 3