An administrator connected a new fiber cable and transceiver to interface Ethernet1/1 on a Palo Alto Networks firewall. However, the link does not seem to be coming up.
If an administrator were to troubleshoot, how would they confirm the transceiver type, tx-power, rx-power, vendor name, and part number via the CLI?
To confirm details like the transceiver type, tx-power, rx-power, vendor name, and part number via the CLI on a Palo Alto Networks firewall, the appropriate command to use is 'show system state filter sw.dev.interface.config'. This command provides detailed state information about the device's interfaces, including physical layer details that are relevant for troubleshooting a fiber link issue.
The correct syntax should be show system state filter-pretty sys.s1.p1.phy, where s is slot 1, p is port one = ethernet1/1
C is correct
On the 1/23/24 test with a different wording
C - https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000Cld3CAC&lang=en_US
funny command , 'filter-pretty' filter-cute
C is correct https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000Cld3CAC&lang=en_US