After a system panic, the NetApp Support team advises you to run the sldiag command.
Which two actions must be performed before you use this command? (Choose two.)
After a system panic, the NetApp Support team advises you to run the sldiag command.
Which two actions must be performed before you use this command? (Choose two.)
To run the sldiag command after a system panic, you need to prepare the system by entering diagnostic mode. First, at the storage system prompt, you should type halt to stop the normal operation of the system. Then, at the LOADER prompt, type boot_diags to boot the system into diagnostic mode where the sldiag command can be executed.
B&C https://docs.netapp.com/platstor/index.jsp?topic=%2Fcom.netapp.doc.hw-plat-diag%2FGUID-2665B3AF-FBEA-4BF5-8A9A-20582883C17E.html