You installed a new AFF A800 2-node ONTAP 9.5 cluster and are asked to run diagnostics to validate the hardware.
Which command is used from the loader prompt to enter diagnostics?
You installed a new AFF A800 2-node ONTAP 9.5 cluster and are asked to run diagnostics to validate the hardware.
Which command is used from the loader prompt to enter diagnostics?
The correct command to enter diagnostics from the loader prompt on an AFF A800 2-node ONTAP 9.5 cluster is 'boot_diags'. This command is used to initiate the diagnostic environment, after which specific diagnostic commands like 'sldiag' can be executed.
D is correct. Use boot_diags at LOADER PROMPT to enter diagnostics and load special sldiag drivers. -----Then use sldiag to execute diagnostics commands.
https://docs.netapp.com/platstor/index.jsp?topic=%2Fcom.netapp.doc.hw-plat-diag%2FGUID-C521BDED-44DA-45B7-BC42-C09B754DD70E.html