Examice

Exam NS0-183 All QuestionsBrowse all questions from this exam

Go to Exam

Question 48

Click the Exhibit button.

You want to add a FAS2750 HA pair to an existing 6-node cluster.

Referring to the exhibit, which action would you perform to begin adding the node?

Use the back command to begin the Cluster Setup wizard.

Reboot the node and enter maintenance mode and run the Cluster Setup wizard.

Use the node setup wizard and select 0a as the management interface.

Use the exit or quit commands then run the cluster setup command.

Correct Answer: D

To add a FAS2750 HA pair to an existing 6-node cluster, you should first exit the current node setup wizard by using the exit or quit command. After exiting, you need to run the cluster setup command to begin configuring the new nodes for the cluster. This process ensures that the nodes are added correctly to the existing cluster.

Discussion

Guss_122Option: D

D is the good answer. https://docs.netapp.com/ontap-9/index.jsp?topic=%2Fcom.netapp.doc.dot-cm-sag%2FGUID-B13FF812-785E-4E62-9914-30E7A8F51A4C.html&lang=en

khanas0hOption: D

answer is D https://docs.netapp.com/ontap-9/index.jsp?topic=%2Fcom.netapp.doc.dot-cm-sag%2FGUID-B13FF812-785E-4E62-9914-30E7A8F51A4C.html

mppcood5Option: D

Option C may be a good choice if it is an e0a port. [2023-04-11 ] Existing cluster interface configuration found: [2023-04-11 ] [2023-04-11 ] PortMTUIPNetmask [2023-04-11 ] e0a9000169.254.127.213255.255.0.0 [2023-04-11 ] e0b9000169.254.218.108255.255.0.0 [2023-04-11 ] [2023-04-11 ] Do you want to use this configuration? {yes, no} [yes]: yes

e3lOption: C

C could be the correct answer. however 0a (or actually e0a) is used for the cluster network. however, this shown wizard is used for adding a node to the cluster