You need to configure a LAG between your switches.
In this scenario, which two statements are correct? (Choose two.)
You need to configure a LAG between your switches.
In this scenario, which two statements are correct? (Choose two.)
When configuring a Link Aggregation Group (LAG), the duplex and speed settings must match on both participating devices to ensure proper communication and data transfer. Additionally, while it might seem logical to assume that member links need to be contiguous ports for simplicity, it is not a requirement. Member links in a LAG can be non-contiguous, meaning they do not need to be sequentially ordered ports on the switch. This flexibility can be beneficial in various network design scenarios.
Up to 64 Ethernet interfaces can be grouped to form a LAG, and In a Junos Fusion, up to 1,000 LAGs are supported on QFX10002 switches acting as aggregation devices. The LAG must be configured on both sides of the link. The interfaces on either side of the link must be set to the same speed and be in full-duplex mode.
BC are correct
B,C are correct