HPE6-A44 Exam - Question 29

Question

Refer to the exhibit.

Controllers are configured in a cluster as shown in the exhibit. These are the network details.

-A Mobility Master (MM) managers the cluster.

-The cluster contains two controllers: C1 and C2.

-AP1 and AP2 use C1 as their Active AP Anchor Controller (A-AAC), with C2 as their Standby AAC (S-AAC).

-AP3 and AP4 use C2 as their A-AAC with, C1 as their S-AAC.

User1 establishes a wireless connection via AP1, where the Active User Controller (U-UAC) assigned is C1, with C2 as the standby. What happens when User1 roams the wireless network and eventually their session is handled by AP3?

Examice · Accepted Answer

When User1 roams the wireless network and their session is handled by AP3, the AP3's Active AP Anchor Controller (A-AAC) remains on C2 because AP3 uses C2 as its A-AAC and does not switch to C1. The user's Active User Controller (A-UAC) remains on C1, since the user initially established the connection through AP1 where C1 was the User's A-UAC. In a typical cluster setup, the user's A-UAC does not change as they roam between access points in the same cluster. Therefore, the correct answer is that AP3’s A-AAC switches to C2, and the user’s A-UAC remains on C1.

god_father · Answer

should be D:

HPE6-A44 Exam - Question 29

Discussion