Refer to the exhibits.
In the wireless configuration shown in the exhibits, an AP is deployed in a remote site and has a wireless network (VAP) called Corporate deployed to it.
The network is a tunnelled network; however, clients connecting to a wireless network require access to a local printer. Clients are trying to print to a printer on the remote site, but are unable to do so.
Which configuration change is required to allow clients connected to the Corporate SSID to print locally?
To allow clients connected to the Corporate SSID to print locally, the split-tunneling configuration on the VAP (Virtual Access Point) profile is needed. This is necessary because split-tunneling must be enabled on the VAP to route the print traffic locally, bypassing the default tunnel configuration to the central site. The current wtp-profile already has split-tunneling enabled, but the configuration is incomplete without enabling it on the VAP profile. Therefore, configuring split-tunneling in the VAP configuration will ensure local print traffic is handled correctly.
A is correct as you need to enable split-tunelling on the vap SSID profile. This is also mentioned on page 323 of study guide
A - Page 323
Answer B is correct . Split tunnel can be enable on the profile
it already is enabled in wtp-profile, according to configuration above, so the correct answer is A where it still needs to be enabled
split-tunnel has to be configured both on vap and wtp-profile, but in this case the correct answer is A since it already has been enabled in wtp-profile according to configuration