nse7_sdw-72 Exam QuestionsBrowse all questions from this exam
Go to Exam

nse7_sdw-72 Exam - Question 1

Refer to the exhibit.

The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths. However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths.

Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so spokes can learn other spokes prefixes and their additional paths? (Choose three.)

Show Answer
Correct Answer: BCD

To ensure that BGP can properly advertise prefixes from spokes to other spokes over the IPsec overlays and include additional paths, the administrator must configure the following settings inside each BGP neighbor group: Enable route-reflector-client, which is essential for reflecting routes to other BGP neighbors without the need for a full mesh configuration. Set additional-path to send enables the sending of multiple paths for the same prefix, thus allowing additional path advertisements. Set adv-additional-path to the number of additional paths to advertise, ensuring that the BGP router advertises additional paths to its BGP peers. These configurations collectively facilitate the desired routing behavior in the described BGP setup.

Discussion

8 comments
Sign in to comment
TTOG
Apr 5, 2024

I wanted to share with you my experience (sadly the exam comment section is removed) : I passed the exam a couple of days ago. There were 40 questions 5-6 of them not from here. A friend of mine failed it, most of his questions were not from here, some of them were from 7.0 he found out later.

ipv84
Apr 8, 2024

Hi TTOG, so if I understand correctly what you have said, the questions for the 7.2 exam is a mix of questions between these and those of 7.0 ?

J_Olin
May 11, 2024

That is very typical in Fortinet exams. They aren't going to rewrite a whole new test when really only about 5% of the content changed (the part related to new features). Always study at least the current exam version and the one previous.

alejandrofern43Options: BCD
Mar 18, 2024

Enable route-reflector-client (pag 239 Sd WAN Study guide for fortios-72) set additional-path to send (pag 252/290 Sd WAN Study guide for fortios-72) set adv-additional-path to the number of addional paths to advertise (pag 290 Sd WAN Study guide for fortios-72)

IBB90704Options: BCD
Mar 8, 2024

B,C y D son correctas

romartinedgOptions: BCD
Jun 12, 2024

B: enable route-reflector-client | Guia 7.2 pag. 240 C: additional-path to send | Guia 7.2 pag. 254 D: adv-additional-path | Guia 7.2 pag. 254

ac89lOptions: BCD
Mar 9, 2024

correct

KavinTOptions: BCD
Mar 10, 2024

B & C & D are correct

nse_studentOptions: BCD
Apr 7, 2024

BCD are correct!

mitkotestOptions: BCD
Apr 11, 2024

B & C & D are correct