Scenario: While performing a disaster recovery test, a Citrix Administrator decides to failover the Citrix ADC high availability (HA) pair appliances. The administrator notices that the failover is NOT working as expected, and the secondary Citrix ADC is NOT taking over as primary. The administrator suspects that networking issues may be causing the failure.
What could be the cause of this issue?
If high availability (HA) monitoring is enabled on an interface of the secondary node that shows as ENABLED but DOWN, it would prevent the secondary Citrix ADC from detecting the primary node as down and consequently taking over as the primary. This situation typically indicates a networking issue or a misconfigured interface, aligning with the observed failover problems in the scenario.
voting A
Correction again. A is correct. Sorry. https://docs.citrix.com/en-us/citrix-adc/current-release/getting-started-with-citrix-adc/configure-ha-first-time.html#:~:text=the%20Nodes%20tab.-,Disable%20high%20availability%20monitoring%20for%20unused%20interfaces,The%20cable%20connecting%20the%20interface%20is%20not%20working%20properly,-Through%20CLI
A. When joining a new node to the HA pair, you should select "Turn off HA Monitor interface/channels that are down checkbox."
Correction. B is the correct answer. https://docs.citrix.com/en-us/citrix-adc/current-release/getting-started-with-citrix-adc/configure-ha-first-time.html#:~:text=To%20set%20up,for%20unused%20interfaces.
I go with b
Correction its a, admin please delete my previous answer