Due to a shortage of physical interfaces on a device, the administrator requires that a loopback for RTP is used. Which command is required when using a loopback interface for RTP?
Due to a shortage of physical interfaces on a device, the administrator requires that a loopback for RTP is used. Which command is required when using a loopback interface for RTP?
The correct command to use a loopback interface for RTP is 'voice-class sip bind media source-interface Loopback0'. This command binds the SIP media traffic to the specified loopback interface, addressing the administrator's requirement due to a shortage of physical interfaces on the device.
Configuring SIP Binding 6. Use one of the following commands to configure SIP binding: - voice-class sip bind media {source-address ipv4 ipv4-address | source-interface interface-id [ipv6-address ipv6-address]} in dial-peer configuration mode. https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book/voi-sip-bind.html#GUID-89132FC8-B523-420B-A48F-0A5FC853E55A