An engineer needs to configure a Cisco Secure Email Gateway (SEG) to prompt users to enter multiple forms of identification before gaining access to the SEG.
The SEG must also join a cluster using the preshared key of cisc421555367. What steps must be taken to support this?
To configure a Cisco Secure Email Gateway (SEG) to prompt users for multiple forms of identification, enabling two-factor authentication is necessary. This can be accomplished through a RADIUS server. Additionally, to join a cluster, the SEG must be configured via the CLI using the preshared key. Therefore, the correct steps are to enable two-factor authentication through a RADIUS server and join the cluster via the SEG CLI.
Q211 same question with conflicting answer!! Any suggestions?
C is correct. Only Radius is supported. Cluster configuration is only via CLI
A is correct. Joining cluster is from GUI (its configuration is in CLI)
C is correct: https://www.cisco.com/c/en/us/support/docs/security/email-security-appliance/200885-ESA-Cluster-Requirements-and-Setup.html#toc-hId-1251782448