An engineer must enable AVC on a Cisco Catalyst 9800 WLC and send the NetFlow data to a NetFlow collector. What must be configured on the controller with the IP address and port number of the NetFlow collector?
An engineer must enable AVC on a Cisco Catalyst 9800 WLC and send the NetFlow data to a NetFlow collector. What must be configured on the controller with the IP address and port number of the NetFlow collector?
To send NetFlow data to a NetFlow collector, the engineer must configure a flow exporter on the Cisco Catalyst 9800 WLC. The flow exporter allows defining the IP address and port number of the NetFlow collector, which is essential for forwarding NetFlow data to the specified collector.
Correct
Correct
To enable Application Visibility and Control (AVC) on a Cisco Catalyst 9800 Wireless LAN Controller (WLC) and send NetFlow data to a NetFlow collector, you must configure a flow exporter. The flow exporter specifies the IP address and port number of the NetFlow collector where the data will be sent. Explanation of the options: A. flow exporter: This is correct. The flow exporter is used to define the destination (IP address and port) of the NetFlow collector. B. flow policy: A flow policy is used to define actions (e.g., marking, policing) applied to traffic flows, but it does not specify the NetFlow collector's IP address and port. C. flow monitor: A flow monitor is used to associate a flow record with an interface to collect traffic data, but it does not specify the NetFlow collector's IP address and port. D. flow record: A flow record defines the specific traffic attributes (e.g., source IP, destination IP, protocol) to be collected, but it does not specify the NetFlow collector's IP address and port.