Refer to the exhibit. An engineer must advertise LAN network 192.168.1.0 of router A to router B through OSPF. The engineer notices that router B was configured, but the LAN network of router A is not in the routing table of router B. Which configuration on router A resolves the problem?
To advertise the LAN network 192.168.1.0 from Router A to Router B via OSPF, the correct configuration must include enabling OSPF for both networks on Router A. This means including 'ospfv3 1 ipv4 area 1' under the GigabitEthernet0/0/0 interface, as well as the Serial0/0/0 interface. Option A correctly configures OSPF for both the 192.168.1.0 network (GigabitEthernet0/0/0) and the 10.0.0.0 network (Serial0/0/0), ensuring that both networks are advertised through OSPF. The suggested answer and discussion missed the fact that Option B did not include the necessary OSPF commands under both interfaces.
Only B has ospfv3 properly setup on the all the interfaces required
agree with B, seems OSPF is correct enabled on both interfaces