Refer to the exhibit. Site1 must perform unequal cost load balancing toward the segments behind Site2 and Site3. Some of the routes are getting load balanced but others are not. Which configuration allows Site1 to load balance toward all the LAN segments of the remote routers?
To enable unequal cost load balancing in EIGRP, the router must use the variance command to include routes with feasible distances within a certain multiple of the best route's feasible distance (FD). In this scenario, Site1 has to perform the balancing. Since some routes are already being balanced under the current variance of 2, increasing it to 3 will ensure that all eligible routes are included. This is calculated by comparing the FD of the feasible successors to the FD of the successor routes to ensure they fit within the variance multiplier. Therefore, setting variance to 3 on Site1 will allow for proper unequal cost load balancing for all LAN segments of the remote routers.
Agree with answer "D". https://networklessons.com/eigrp/eigrp-variance-command-example FD of feasible successor / FD of successor ≈ variance 691200 / 230400 = 3 (variance 3) 563200 / 307200 = 1,833 (variance 2) 665600 / 435200 = 1,529 (variance 2)
Yeah and this need to happy only in site 1, so is the only answer that apply in this question
I’ve noticed that there are a lot of question where “refer to the exhibit” is actually not needed. If variance 2 is aleatory applied a not sufficient, then we have to increase it to 3
D is correct