Refer to the exhibit. Which statement about R1 is true?
Refer to the exhibit. Which statement about R1 is true?
The given configuration shows a route map named 'ADD' with a permit clause, and it sets a tag value of 1. The route map is referenced when redistributing RIP routes into OSPF. Since there is no match condition specified on the route map, it applies to all RIP routes being redistributed. Therefore, all RIP learned routes are tagged with a value of 1 when redistributed into OSPF.
B is correct. If there is no match statement, it matches everything.
B is the correct answer. Once there is no more configuration under the route-map and it's applied on the rip redistribution inside ospf, the router it is going to add a TAG 1 over in all route that came from RIP.
If a match command is not present, all routes match the clause. In the previous example, all routes that reach clause 30 match; therefore, the end of the route-map is never reached. https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/49111-route-map-bestp.html
In the exhibit, the route map route-map ADD permit 20 set tag 1... is not matching any ip, so the route map is not tagging the RIP routes when redistributed. Best answer for me is D.
B is correct
Agreed B is the correct answer.
The given answer is correct
The given answer is correct
The answer is B -- https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/route_maps.pdf "• If a match command or Match Clause value in ASDM is not present, all routes match the clause. In the previous example, all routes that reach clause 30 match; therefore, the end of the route map is never reached."