Refer to the exhibit. Which command set enables router R2 to be configured via NETCONF?
Refer to the exhibit. Which command set enables router R2 to be configured via NETCONF?
To enable router R2 to be configured via NETCONF, the correct command set involves configuring a username with the appropriate privilege level and enabling NETCONF-YANG. The appropriate commands are: defining a username with 'privilege 15' and specifying a password, and ensuring NETCONF-YANG is enabled. The commands in option B match these requirements, where 'netconf-yang' and its features are properly enabled for NETCONF configuration.
B like 100%
A is missing the privilege 15 AAA credentials B is correct
https://developer.cisco.com/docs/ios-xe/#!enabling-netconf-on-ios-xe/authentication
netconf-yang
No one going to mention that face that the answers are giving a configuration response for "R1" which doesn't even exist in the exhibit??
It happened to me once that i restarted wrong core switch during maintenance works, almost no one noticed :) Only one of my senior asked me smth aka ~did something just blinked or it was my computer..?
I would say A base on this link: https://developer.cisco.com/docs/ios-xe/#!enabling-restconf-on-ios-xe/httphttps RESTCONF runs over HTTPS. The following commands must be enabled to support ip http secure-server The CLI command to enable RESTCONF is displayed below: restconf
I'm sorry I read RESTCONF instead of NETCONF.... I think B is the correct answer
trust the comments. i will go with B
trust the comments. i will go with B
Also voting A
Is this really correct?