You noticed that CPU cores on the Security Gateway are usually 100% utilized and many packets were dropped. You don't have a budget to perform a hardware upgrade at this time. To optimize drops you decide to use Priority Queues and fully enable Dynamic Dispatcher. How can you enable them?
To enable Priority Queues and fully enable Dynamic Dispatcher to optimize dropped packets without hardware upgrades, the correct command is 'fw ctl multik set_mode 9'. This command is used to activate these features on the Security Gateway.
R77.30 exam - correct answer is C R80. exam - correct answer is A
According to the reference link, CoreXL Dynamic Dispatcher is disabled by default in R77.30 and the command is: fw ctl multik set_mode 9 However, in R80+, CoreXL Dynamic Dispatcher is enabled by default, and the command is: fw ctl multik dynamic_dispatching on So both are correct, depending on your version. Which one does the exam count as correct then?
In a real exam always the answer to the current version is right. Keep this is mind! So in this case the answer A for R80+ is right.
For R80, the command to enable it is # fw ctl multik dynamic_dispatching on so, A is the correct answer
You're right. Reference: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk105261
+For R80.10 and HIGHER: " [<a href="/cdn-cgi/l/email-protection" class="__cf_email__" data-cfemail="e8ad90988d9a9ca8bad0d8c6d9d8">[email protected]</a>:0]# fw ctl multik dynamic_dispatching on New mode is: On Please reboot the system [<a href="/cdn-cgi/l/email-protection" class="__cf_email__" data-cfemail="61241911041315213359514f5051">[email protected]</a>:0]# "
https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk105261
if you have 100% CPU and much drops - you need to optomize drops)) :-D this problem much more complicated...