To enable Dynamic Dispatch on Security Gateway without the Firewall Priority Queues, run the following command in Expert mode and reboot:
To enable Dynamic Dispatch on Security Gateway without the Firewall Priority Queues, run the following command in Expert mode and reboot:
To enable Dynamic Dispatch on a Security Gateway without the Firewall Priority Queues, the correct command is 'fw ctl multik set_mode 1'. This command sets the multi-core inspection mode necessary for enabling Dynamic Dispatch, whereas other options either enable or disable other specific modes or features not related to Dynamic Dispatch in the described manner.
C is Wrong. #fw ctl multik prioq Current mode is On Available modes: 0. Off 1. Evaluator-only 2. On Choose the desired mode number: (or 3 to Quit) 3 # fw ctl multik prioq 2 Current mode is On New mode is: On
Had this question today in exam.
fw ctl multik prioq 2
To enable Dynamic Dispatcher on a Security Gateway without the Priority Queues, run the following command in Expert mode: fw ctl multik prioq
A good phrase from CCSE, but it further says that you need to choose one of the options and there is no description.
ccse page 419 answer is C
is correct To enable Dynamic Dispatcher on a Security Gateway without the Firewall Priority Queues, run the following command in Expert mode and reboot: fw ctl multik prioq 2
This is not right. Correct answer is not listed here. "To enable Dynamic Dispatcher on a Security Gateway without the Firewall Priority Queues, run the following command in Expert mode and reboot: fw ctl multik set_mode 4"
Yes... response is not listed... [<a href="/cdn-cgi/l/email-protection" class="__cf_email__" data-cfemail="27625f5742555367751f17091617">[email protected]</a>:0]# fw ctl multik dynamic_dispatching on New mode is: On Please reboot the system
But response is good, as : https://sc1.checkpoint.com/documents/R80.40/WebAdminGuides/EN/CP_R80.40_PerformanceTuning_AdminGuide/Content/Topics-PTG/CLI/fw-ctl-multik-prioq.htm
fw ctl multik set_mode 4 good for R77
I think same you, the correct answer is not listed here, I think the correct would be: fw ctl multik prioq 0 No Parameters Shows the interactive menu for configuration of the CoreXL Firewall Priority Queues. 0 Disables the CoreXL Firewall Priority Queues. 1 Enables the CoreXL Firewall Priority Queues in the Evaluator-only mode. 2 Enables the CoreXL Firewall Priority Queues.
fw ctl multik prioq [{0 | 1 | 2}] Shows the interactive menu for configuration of the CoreXL Firewall Priority Queues. 0 -- Disables the CoreXL Firewall Priority Queues. 1 -- Enables the CoreXL Firewall Priority Queues in the Evaluator-only mode. 2 -- Enables the CoreXL Firewall Priority Queues.