If SmartLog is not active or failed to parse results from server, what commands can be run to re-enable the service?
If SmartLog is not active or failed to parse results from server, what commands can be run to re-enable the service?
To re-enable the SmartLog service, the appropriate commands to use are 'smartlogstart' and 'smartlogstop'. The 'smartlogstart' command initiates the service, and 'smartlogstop' command stops it, which can help in troubleshooting and resetting the service. Options involving commands like 'smartlogrestart', 'smartloginit', or 'smartlogsetup' are not correct since these commands do not exist for this purpose.
Correct answer is B There is no command "smartlogrestart"
When this module is not running, you see the SmartLog is not active or Failed to parse results from server message in the SmartConsole / Logs & Monitor / Logs view. To start or stop the module, use the commands below: smartlogstart smartlogstop To debug the module, run the smartlogs top command and then run the following command: env TDERROR ALL ALL=5 $SMARTLOGDIR/smartlog_server >& <output_filename>
Correct answer is B