To enable Dynamic Dispatch on Security Gateway without the Firewall Priority Queues, run the following command in Expert mode and reboot:
To enable Dynamic Dispatch on Security Gateway without the Firewall Priority Queues, run the following command in Expert mode and reboot:
To enable Dynamic Dispatch on Security Gateway without the Firewall Priority Queues, you must use the command 'fw ctl multik set_mode 1'. This command configures the Security Gateway's multi-core support mode, specifically setting it to use Dynamic Dispatcher without the use of Firewall Priority Queues.
Answer is B, according to https://support.checkpoint.com/results/sk/sk105762
[Expert@NetSevGw1:0]# fw ctl multik prioq Current mode is On Available modes: 0. Off 1. Evaluator-only 2. On Choose the desired mode number: (or 3 to Quit)
answer is B [Expert@NetSevGw1:0]# fw ctl multik prioq Current mode is On Available modes: 0. Off 1. Evaluator-only 2. On Choose the desired mode number: (or 3 to Quit)
None of them is correct. The correct answer is: fw ctl multik dynamic_dispatching on
From the CCSE study Guide:- To enable Dynamic Dispatcher on a Security Gateway without the Priority Queues, run the following command in Expert mode: fw ctl multik prioq You then have 3 options :- 0. Off 1. Evaluator only 2. On So I think the correct command is:- fw ctl multik prioq 0 So none of the answers given are correct!
Looks like A. https://support.checkpoint.com/results/sk/sk105261 But should be 4.