ACE-A1.2 Exam QuestionsBrowse all questions from this exam

ACE-A1.2 Exam - Question 7


When an Arista switch boots with no startup-config and ZTP enabled, before ZTP receives an IP address, in what state are the front-panel interfaces?

Show Answer
Correct Answer: C

When an Arista switch boots with no startup-config and ZTP enabled, it configures all Ethernet and Management interfaces with the no switchport command. This means that all interfaces are routed ports (no switchport) before ZTP receives an IP address.

Discussion

3 comments
Sign in to comment
gksongOption: C
Oct 16, 2019

When an Arista switch boots for the first time, ZTP is enabled. The switch sees that there is no startup-config, so it configures all interfaces with the no switchport command, then sends out DHCP queries on any Ethernet and Management interfaces.

manhtran93Option: C
Jan 6, 2020

The correct answer should be C

network_guruOption: C
Jan 29, 2021

Arista Warrior 2 confirms this (gksong is correct). "When a switch boots in ZTP mode, it configures all the Ethernet and Management interfaces with the no switchport command.." Chapter 25 Section: Booting with ZTP.. page 305..