Which command will successfully configure Ethernet5 to be 40Gbps on an Arista 7150-52 switch?
Which command will successfully configure Ethernet5 to be 40Gbps on an Arista 7150-52 switch?
To configure Ethernet5 to operate at 40Gbps on an Arista 7150-52 switch, the correct command would be 'Arista(config-if-Et5)#speed 40gfull'. This command sets the interface speed to 40Gbps in full-duplex mode. The 'forced' keyword is not required in the command syntax for this switch model.
B is correct, Et5 is non-primary ports
Thats right, answer is B, by default all ports is 10G and if wanna use 40G, need to make an Agile Port(combination of 4x10G ports0 to form 1x40G port.
B can't be correct because e 5 is 40G and not 10G on 7150 https://www.arista.com/assets/data/pdf/Datasheets/7150S_Datasheet.pdf
B can't be correct because e 5 is 40G and not 10G on 7150-50 https://www.arista.com/assets/data/pdf/Datasheets/7150S_Datasheet.pdf
Sorry Not 7150-50 BUT 7150-52 as seen clearly on the Switch. B can't be correct because e 5 is 40G and not 10G on 7150-52. I stay with C https://www.arista.com/assets/data/pdf/Datasheets/7150S_Datasheet.pdf