An administrator is running the following sniffer in a FortiGate: diagnose sniffer packet any "host 10.0.2.10" 2
What information is included in the output of the sniffer? (Choose two.)
Question 6 of 71
Correct Answer: B, C
When running the command 'diagnose sniffer packet any "host 10.0.2.10" 2' on a FortiGate, the sniffer captures packets with a verbosity level of 2. At this level, the output includes the IP headers and the IP payload of the packets. Specifically, verbosity level 2 includes header information up to the IP layer and the actual data being transmitted in the IP payload. Ethernet headers are included in verbosity level 3 and above, while port names are not included in this output.
Question 7 of 71
Examine the partial output from two web filter debug commands; then answer the question below:
Based on the above outputs, which is the FortiGuard web filter category for the web site www.fgt99.com?
Correct Answer: D
The FortiGuard web filter category for the website www.fgt99.com is 52, corresponding to Information Technology. The hex value 34000000 converts to decimal 52.
Question 8 of 71
Examine the output of the "˜get router info ospf interface' command shown in the exhibit; then answer the question below.
Which statements are true regarding the above output? (Choose two.)
Correct Answer: A, C
The port4 interface is in OSPF backbone area, this is verified by the area ID 0.0.0.0 mentioned. Additionally, the neighbor count being 4 along with an adjacency count of 2 indicates that there are at least five OSPF routers in the port4 network: the local router and its four neighbors.
Question 9 of 71
Examine the output of the "˜get router info bgp summary' command shown in the exhibit; then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
Correct Answer: A, C
The BGP state of the peer 10.125.0.60 is Established, as indicated by the Up/Down time of 03:02:49 and a prefix received count of 1. This confirms that the BGP session is successfully established with this peer. On the other hand, the BGP peer 10.200.3.1 is in the 'Active' state, which means it has not established a TCP connection. This also implies that the local BGP peer has not received an OpenConfirm from 10.200.3.1.
Question 10 of 71
Examine the following partial output from a sniffer command; then answer the question below.
What is the meaning of the packets dropped counter at the end of the sniffer?
Correct Answer: D
The dropped packets counter at the end of the sniffer indicates the number of packets that matched the sniffer filter but could not be captured by the sniffer. This typically happens when the system is overwhelmed with traffic and cannot handle capturing all the filtered packets, leading to some being dropped.