HP HPE0-Y53 Exam Questions

Question 6 of 105

DRAG DROP -
Evaluate each scenario for multi-tenant isolation, and match the scenario to the technology that best meets its needs.
Select and Place:
Exam HPE0-Y53: Question 6 - Image 1

Question 7 of 105

Refer to the exhibits on the Exhibit 1 and Exhibit 2 tabs.

Exhibit 1 -
Exam HPE0-Y53: Question 7 - Image 1

Exhibit 2 -
Exam HPE0-Y53: Question 7 - Image 2

A company has three HP VAN SDN Controllers deployed in a team with the settings shown in the exhibits. What is the correct OpenFlow controller configuration for the OpenFlow instance on the switch with IP address 10.1.1.252?

A.

one controller with IP address 192.168.56.14

B.

two controllers with IP addresses 192.168.56.14 and 192.168.56.16

C.

one controller with IP address 192.168.56.16

D.

three controllers with IP addresses 192.168.56.14, 192.168.56.15, and 192.168.56.16

E.

one controller with IP address 192.169.81.84

Question 8 of 105

A company requires secure, encrypted connections between OpenFlow-enabled switches and the HP VAN SDN Controller. What could the network administrator do to meet this requirement?

A.

Configure TLS and certificates for the connection to the OpenFlow controller.

B.

Configure the OpenFlow instance to use SSH and set up matching passwords on the switches and controller.

C.

Configure fail secure mode on the OpenFlow instance.

D.

Configure the controller connection on the switch out-of-band management (OOBM) port.

Question 9 of 105

Refer to the exhibit.
Exam HPE0-Y53: Question 9 - Image 1

Switch 1 is operating in NPV mode, and Switch 2 is operating in FCP mode. Which Switch 1 interface should be set to "np" for the FC mode?

A.

interface VFC 2

B.

interface Ten-GigabitEthernet 1/0/2

C.

interface Ten-GigabitEthernet 1/0/1

D.

interface VFC 1 D

Question 10 of 105

Refer to the exhibit.
Exam HPE0-Y53: Question 10 - Image 2

The switches shown in the exhibit are HP Comware switches that support FCoE. The servers access the storage using FCoE. What should be configured on the
Ten-GigabitEthernet1/0/1 interface of Switch1?

A.

a QoS policy for Enhanced Transmission Selection (ETS)

B.

the LLDP TLVs for data center bridging extensions (DCBX)

C.

priority flow control (PFC) in manual mode

D.

the LLDP TLVs for Enhanced Transmission Selection (ETS)