HP HP0-Y52 Exam Questions

Question 6 of 116

Refer to the Exhibit.
Exam HP0-Y52: Question 6 - Image 1

Exam HP0-Y52: Question 6 - Image 1

Examine the output from the Comware command shown in the exhibit. Based on the flag of ACDEF, what is the status of the aggregated link?

A.

Static LACP link aggregation is configured, and the aggregated link is operational with load sharing not being performed.

B.

Static link aggregation is configured, and the aggregated link is operational with load sharing being performed.

C.

Static LACP link aggregation is configured, and the aggregated link is operational with load sharing being performed.

D.

Static link aggregation is configured, and the aggregated link is operational with load sharing not being performed.

Suggested Answer: B

Community votes

No votes yet

Question 7 of 116

A network administrator enters this command on an HP Comware switch:
<Comware> save
In interactive mode, the administrator is prompted to save to a file named config.cfg and confirms the save. What is the effect of these actions?

A.

The current configuration is saved to config.cfg on a TFTP server but is not used for the startup-config.

B.

The startup-config, rather than the correct configuration, is saved to config.cfg on a TFTP server.

C.

The current configuration is saved to config.cfg in the flash but is not used for the startup-config.

D.

The current configuration is saved to config.cfg in the flash and is used for the startup-config.

Suggested Answer: D

Community votes

No votes yet

Question 8 of 116

A customer is implementing a network using HP ProVision switches. Which default setting applies to the ProVision switches?

A.

All ports are disabled.

B.

Routing is enabled.

C.

Telnet is enabled.

D.

A static IP address is assigned to VLAN 1.

Suggested Answer: C

Community votes

No votes yet

Question 9 of 116

A company needs a two-member Intelligent Resilient Framework (IRF) virtual switch. The network administrator is configuring IRF member 2 that will connect to port 1/1 on IRF member 1. What is the correct IRF port ID for member 2?

A.

1/2

B.

2/2

C.

1/1

D.

2/1

Suggested Answer: B

Community votes

No votes yet

Question 10 of 116

A customer wants to implement multiple links between a server and a single HP Comware switch in order to increase the amount of bandwidth for more throughput. Which feature should the network administrator implement to accomplish this?

A.

MSTP

B.

IRF

C.

link aggregation

D.

MIMO

Suggested Answer: B

Community votes

No votes yet