CWNP CWDP-304 Exam Questions

Question 6 of 60

In WLAN design software, what is an example of a project parameter that can be defined before importing files or performing design actions?

AP locations

AP type selection

Minimum required signal strength

Floor plan

Correct Answer: C

Question 7 of 60

For a point-to-point bridge link spanning 1200 meters, which antenna is the most appropriate and requires the least Intentional Radiator power?

2.2 dBi omnidirectional

11 dBi omnidirectional

11 dBi dish

5 dBi patch

Correct Answer: C

Question 8 of 60

You are tasked with conducting a site survey to measure signal strength, throughput, and latency. What type of survey should you perform?

Perform a passive survey using a laptop’s built-in wireless adapter

Perform a passive survey using a USB wireless adapter

Perform an active survey using a laptop’s built-in adapter

Perform a passive survey using a special monitor mode adapter

Correct Answer: C

Question 9 of 60

During the design process of a point-to-point bridge link, which step should be taken to minimize Co-Channel Interference (CCI) and Adjacent Channel Interference (ACI)?

Choose a channel on the 5 GHz band outside of the UNII-1 and UNII-3 channels

Choose a channel on the 2.4 GHz band other than the over used 1, 6 and 11

Install the antennas and choose the least busy channel using trial and error problem solving

Perform an outdoor site survey in the area of both buildings and determine the best channel to use

Correct Answer: D

Question 10 of 60

Before beginning the actual design process in most WLAN design tools, what action is typically required after defining project parameters or completing the project creation wizard?

Place APs

Define cabling

Import a floor plan

Define wall materials

Correct Answer: C