Automating Cisco Service Provider Solutions (SPAUTO)

Here you have the best Cisco 300-535 practice exam questions

  • You have 45 total questions to study from
  • Each page has 5 questions, making a total of 9 pages
  • You can navigate through the pages using the buttons at the bottom
  • This questions were last updated on December 20, 2024
Question 1 of 45

DRAG DROP -

Drag and drop the steps from the left into the correct order on the right to deploy an already created service into NSO. Not all options are used.

Select and Place:

    Correct Answer:

    Reference:

    https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2019/pdf/LABSPG-2442.pdf

Question 2 of 45

What tool is used to perform a "what if" failure analysis in a service provider network that is running Segment Routing?

    Correct Answer: D

    The tool used to perform a 'what if' failure analysis in a service provider network that is running Segment Routing is the Cisco Segment Routing Path Computation Element. This tool is specifically designed to compute and analyze paths in a Segment Routing network, which includes simulating various failure scenarios to assess their impact on the network.

Question 3 of 45

Refer to the exhibit. An engineer implements an automation with Cisco XTC. Which problem results in the 404 Not Found error code on the REST call?

    Correct Answer: A

    The 404 Not Found error indicates that the requested resource could not be found on the server. In this context, it likely means that the resource you are trying to delete does not exist. This status code is a standard response to denote that the server can't find the requested URL or resource.

Question 4 of 45

Which command configures the remote peer when the Cisco IOS XR Traffic Controller is used?

    Correct Answer: D

    The command 'state-sync ipv4 192.168.0.3' configures the remote peer for state synchronization when using the Cisco IOS XR Traffic Controller. This command is typically used at the Path Computation Element (PCE) to enable remote peer communication for state synchronization, ensuring that two PCE servers can maintain synchronized state information.

Question 5 of 45

An automation engineer is trying to configure a destination group to use dial-out telemetry with gRPC on a Cisco IOS XR platform. The template created is failing to apply. Which parameters must be configured?

    Correct Answer: D

    When configuring a destination group to use dial-out telemetry with gRPC on a Cisco IOS XR platform, it is essential to specify the destination IP address, destination port, encoding, and protocol. These parameters ensure that the telemetry data is correctly sent to the desired endpoint using the appropriate encoding format and communication protocol (gRPC in this case).