CCNA Cisco Certified Network Associate

Here you have the best Cisco 200-125 practice exam questions

  • You have 775 total questions to study from
  • Each page has 5 questions, making a total of 155 pages
  • You can navigate through the pages using the buttons at the bottom
  • This questions were last updated on October 13, 2025
  • This site is not affiliated with or endorsed by Cisco.
Question 1 of 775
A network administrator needs to configure port security on a switch. Which two statements are true? (Choose two.)
    Correct Answer: C, D

    The sticky learning feature allows the addition of dynamically learned addresses to the running configuration, and when dynamic MAC address learning is enabled on an interface, the switch can learn new addresses up to the maximum defined. These statements accurately describe features of port security configuration on a switch.

Question 2 of 775
Which interface counter can you use to diagnose a duplex mismatch problem?
    Correct Answer: D

    To diagnose a duplex mismatch problem, you can use the CRC errors interface counter. CRC (Cyclic Redundancy Check) errors often occur when there is a duplex mismatch because frames may be transmitted at the same time, leading to errors in the frame check sequence. This is a common indicator of a duplex mismatch issue.

Question 3 of 775
Which switching method duplicates the first six bytes of a frame before making a switching decision?
    Correct Answer: C

    Cut-through switching method duplicates the first six bytes of a frame, which contain the destination address, before making a switching decision. This allows for faster processing because the switch can start forwarding the frame as soon as it has read these bytes, rather than waiting to receive the entire frame.

Question 4 of 775
Which logging command can enable administrators to correlate syslog messages with millisecond precision?
    Correct Answer: D

    The command needed to enable administrators to correlate syslog messages with millisecond precision is 'service timestamps log datetime msec'. This command configures the system to apply a timestamp to logging messages with millisecond precision. When the system includes the keyword 'msec', the time format is displayed as HH:MM:SS.mmm, where .mmm represents the milliseconds.

Question 5 of 775
Which two spanning-tree port states does RSTP combine to allow faster convergence? (Choose two.)
    Correct Answer: A, E

    RSTP (Rapid Spanning Tree Protocol) introduced changes to achieve faster convergence as compared to the classic STP (Spanning Tree Protocol). In STP, there are five port states: blocking, listening, learning, forwarding, and disabled. RSTP reduces these to only three states: discarding, learning, and forwarding. To achieve this reduction and improve the convergence time, RSTP combines the blocking and listening states into a single state called discarding. This combination allows RSTP to quickly move through necessary steps to reach forwarding state without the additional delay previously caused by distinct blocking and listening states. Therefore, blocking and listening are the two states that RSTP combines to allow faster convergence.