Service Provider Routing and Switching, Specialist (JNCIS-SP)

Here you have the best Juniper JN0-363 practice exam questions

  • You have 66 total questions to study from
  • Each page has 5 questions, making a total of 14 pages
  • You can navigate through the pages using the buttons at the bottom
  • This questions were last updated on November 1, 2024
Question 1 of 66

Click the Exhibit button.

You have configured graceful RE switchover (GRES), however you cannot complete the show system switchover command.

Referring to the exhibit, what is the problem?

    Correct Answer: D

    The show system switchover command is only available on the backup Routing Engine. This is because the kernel-replication process daemon, which supports this command, runs only on the backup Routing Engine and not on the primary Routing Engine.

Question 2 of 66

What are three well-known mandatory BGP attributes? (Choose three.)

    Correct Answer: B, D, E

    The three well-known mandatory BGP attributes are origin, AS path, and next hop. These attributes are recognized by all BGP peers, are passed to all peers, and are present in all BGP Update messages. Origin indicates the origin of the route (IGP, EGP, or incomplete), AS path lists the ASes the route has traversed, and next hop specifies the next-hop IP address that should be used to reach the destination.

Question 3 of 66

What is the correct order of BGP attributes for active route selection?

    Correct Answer: B

    The correct order of BGP attributes for active route selection is: next hop, local preference, AS path, origin, and then MED. This sequence is commonly used when determining the best path in BGP routing.

Question 4 of 66

What are two bridging concepts that are used to maintain an Ethernet switching table? (Choose two.)

    Correct Answer: A, C

    Learning and aging are the two bridging concepts used to maintain an Ethernet switching table. Learning allows a switch to record the source MAC address and the port it arrived on when a frame is received, helping to update and build the switching table. Aging ensures that the table remains current by removing entries that have not been refreshed within a certain period, thus preventing the table from becoming cluttered with outdated data and freeing up space for new entries.

Question 5 of 66

Which BGP attribute is used to detect routing loops?

    Correct Answer: A

    The AS path attribute in BGP is used to detect routing loops. It contains the sequence of Autonomous System (AS) numbers that the route has traversed. A BGP router examines the AS path for its own AS number; if found, it will reject the route to prevent loops. This mechanism ensures that a BGP router does not receive a route that it had previously advertised.