Refer to the exhibit. Which configuration change ensures that R1 is the active gateway whenever it is in a functional state for the 172.30.110.0/24 network?
Refer to the exhibit. Which configuration change ensures that R1 is the active gateway whenever it is in a functional state for the 172.30.110.0/24 network?
To ensure that R1 is always the active gateway when it is functional for the 172.30.110.0/24 network, R1 should be configured with the 'preempt' command. This allows R1 to take over as the active router whenever it is available. Additionally, R2 should have a lower priority than R1, so in this case, setting R2's priority to 90 ensures that R1 will take precedence as the active gateway when both routers are functional. The correct configuration is 'R1 standby 1 preempt' and 'R2 standby 1 priority 90'.
The given answer is correct
Setting R1 to preempt means take over the role when online, setting R2 to 90 means it will lose to a higher value in an election. 100 is default.
No, A is correct. For R1 to be active, it must have higher priority. The default is 100, and setting a router to 90 will cause it to lose. Set R2 to 90, not R1.
Please disregard, I misread. Option C does set R2 to 90.
The given answer is correct
This question is still asked. Passed today.
C is correct
default priority is 100 and its in preempt will be chosen as the active gateway, standby configured is 100, it will give back rights(if so to say) when R1 comes online
it could also be the a
C is 100% correct
cisco#show standby Ethernet0/0 - Group 10 State is Active 2 state changes, last state change 00:57:43 Virtual IP address is 172.16.113.254 Active virtual MAC address is 0000.0c07.ac0a Local virtual MAC address is 0000.0c07.ac0a (v1 default) Hello time 3 sec, hold time 10 sec Next hello sent in 1.824 secs Preemption enabled Active router is local Standby router is unknown Priority 100 (default 100) Group name is "hsrp-Et0/0-10" (default) cisco# *Dec 17 22:41:45.948: %HA_EM-6-LOG: CONF_CHANGE: Configuration changed cisco# cisco#sh run int Ethernet0/0 Building configuration... Current configuration : 118 bytes ! interface Ethernet0/0 ip address 172.16.113.2 255.255.255.0 standby 10 ip 172.16.113.254 standby 10 preempt end cisco#
Given answer is correct